Geometry Tools Error—Small Object Removal Failed as Specified ToleranceIssueWhile in the Small Object Removal tab (on the Geometry Tool task dialog), one or both of the following errors appears after adjusting the tolerance and clicking the Remove button: Error: Object suppression failed at the specified tolerance. Reduce tolerance and try again. Error: Small Object Removal failed at the specified tolerance and the previous model state must be restored. Reduce tolerance and try again. SolutionThis error likely indicates that the removal of objects below the specified tolerance was not successful. The model is returned to its state prior to invoking Small Object Removal. To resolve this issue: Reduce the tolerance, and attempt to remove small objects again. This can also point to a potential problem with the geometry. Use the Meshing Diagnostics to try to identify any sliver surfaces or tiny edges (with Surface-mode and Edge-mode diagnostics, respectively).
Support – Terms of UseAUTODESK DOES NOT GUARANTEE THAT YOU WILL BE ABLE TO SUCCESSFULLY DOWNLOAD OR IMPLEMENT ANY SERVICE PACK OR WORKAROUND, OR ANY OF THE TIPS, TRICKS, EXAMPLES OR SUGGESTIONS OUTLINED IN ANY AUTODESK PRODUCT SUPPORT TECHNICAL DOCUMENTS. TECHNICAL DOCUMENTS, SERVICE PACKS AND WORKAROUNDS ARE SUBJECT TO CHANGE WITHOUT NOTICE TO YOU. AUTODESK PROVIDES TECHNICAL DOCUMENTS, SERVICE PACKS AND WORKAROUNDS "AS IS" WITHOUT WARRANTY OF ANY KIND, WHETHER EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL AUTODESK OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF DATA, OR LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, THAT MAY OCCUR AS A RESULT OF IMPLEMENTING ANY SERVICE PACK OR WORKAROUND, OR ANY SUGGESTION OUTLINED IN ANY AUTODESK PRODUCT SUPPORT TECHNICAL DOCUMENT, EVEN IF AUTODESK OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. | 