When you used the Autodesk® Design Review 2009 preview in Productstream® Professional 2009, your DWF file was displayed and some of the DWF command were available, but some of the toolbars (for example, the toolbar containing the Print button) were missing. There seems to be no way for you to enable these toolbars.
Solution
To enable the toolbars in the DWF preview
Note: To perform this procedure, you need to be able to log on as a Productstream Professional Administrator and understand the Productstream Professional configuration.
In Productstream Professional 2009, open the Configuration Editor.
In the Configuration Editor, locate the GuiViews section and the DefaultPreviewDWFView component.
In the DefaultPreviewDWFView component, change the value of the attribute, EnableADRToolbars to 1.
Save the configuration.
Restart Productstream Professional 2009.
To enable the additional toolbars, right-click at the top of the DWF preview in Productstream Professional 2009 and select the desired toolbar from the shortcut menu.
AUTODESK DOES NOT GUARANTEE THAT YOU WILL BE ABLE TO SUCCESSFULLY DOWNLOAD OR IMPLEMENT ANY SERVICE PACK OR WORKAROUND, OR ANY OF THE TIPS, TRICKS, EXAMPLES OR SUGGESTIONS OUTLINED IN ANY AUTODESK PRODUCT SUPPORT TECHNICAL DOCUMENTS. TECHNICAL DOCUMENTS, SERVICE PACKS AND WORKAROUNDS ARE SUBJECT TO CHANGE WITHOUT NOTICE TO YOU. AUTODESK PROVIDES TECHNICAL DOCUMENTS, SERVICE PACKS AND WORKAROUNDS "AS IS" WITHOUT WARRANTY OF ANY KIND, WHETHER EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL AUTODESK OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF DATA, OR LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, THAT MAY OCCUR AS A RESULT OF IMPLEMENTING ANY SERVICE PACK OR WORKAROUND, OR ANY SUGGESTION OUTLINED IN ANY AUTODESK PRODUCT SUPPORT TECHNICAL DOCUMENT, EVEN IF AUTODESK OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
